Installation Instructions for Gas Conversion

3 CHANGE BURNER ORIFICES (cont.)

IMPORTANT: Find your modelnumber below. Read each orifice label to identifyand installthem in the exact locationsshown.

ZDP304 SIMMER ORIFICES

A 34SL or 51SN orifice

will be used on all burners.

ZDP304 MAIN ORIFICES

 

Use a 108XL

A 84XL or

or 190XN orifice

for the right

126HXN orifice

front burner.

will be used

 

on these three

 

burners.

 

ZDP364, ZDP366, ZDP484, ZDP486
SIMMER

 

 

 

 

 

 

 

 

 

 

 

 

 

A 34SL or 51SN orifice

ORIFICES

 

 

 

 

 

 

 

 

 

 

 

 

 

will be used on all

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

burners.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

MAIN

 

 

 

 

 

 

 

Use 108XL or

ORIFICES

 

 

 

 

 

 

 

 

 

 

 

 

190XN orifices

 

 

 

 

 

 

 

 

 

 

 

 

 

for all burners.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

A.Return the unusedorificesto the holder.Reattach the holder and the instructionsheetwith screw in the original storage location.

B.Replacethe burner heads, caps and top grates. On rangemodels, replace rear vent trim.

4 CHANGE GRILL ORIFICE (if present)

Locatethe1–1/2” longGrill orifice.

Selectforyourgastype.LP—.047, NAT—.067

A. Remove the grillcover, grates and grate frame. Lift the radiant baffle straight up and off.

B. Remove the 2 hex

 

 

head screws from

Remove 2

 

the top of the igniter.

 

hex head

 

• Remove one screw

screws

 

from each side of

 

 

the burner surround.

 

 

• Lift out the surround.

Surround

 

 

Screws

 

C. Carefully push the

Burner

Igniter

igniter aside and

Surround

 

under

 

 

the burner.

 

 

Do not pullor pinch

 

 

the wire.

 

Burner

Remove 4 burner

 

Assembly

attachment screws,

 

 

2 at the front and 2

 

 

at the back. Slide the

 

 

burner assembly

 

 

toward the back and

 

 

out of the gas inlet.

 

 

D. Use a 1/2" deep well

Front of Range

 

socket to remove

 

 

and replace the orifice .

Reverse these

steps to re-assemble the grill. Be sure to place the unused orifice in the holder for possiblefuture use.

16