NOTE:
DO NOT run the pump without the water supply connected and turned on. Damage to the equipment resulting from failure to follow these instructions will void warranty.
1.Move the fuel valve lever to the ON position (Figure 24).
Figure 24 – Fuel ValveOff
On
2.Move the choke lever to the “CLOSE” position (Figure 25).
NOTE:
For a warm engine, be sure the choke lever is in the “OPEN” position.Figure 25 – Choke LeverChoke
Open
Close
3.Move the throttle control lever to the “HIGH” position, shown on the engine as a rabbit (Figure 26).
Operation
Figure 26 – Throttle ControlHighLow
4.Turn the engine switch to the "ON" position (Figure 27).
Figure 27 – The ON PositionOFF
ON
IMPORTANT: Before starting the power washer, be sure you are wearing adequate safety goggles.
Risk of eye injury. Spray can splash back or propel objects.
•Always wear safety goggles when using this equipment or in the vicinity of equipment in use.
•Before starting the power washer, be sure you are wearing adequate safety goggles.
•NEVER substitute safety glasses for safety goggles.
5.Place foot on footpad or otherwise secure the unit from movement when pulling the recoil.
6.When starting the engine, grasp the starter grip handle (Figure 28) and pull slowly until you feel some resistance. Then pull rapidly to start engine.
13