Read this owner’s manual and safety rules before operating your power washer.
If you loan this device to someone, ALWAYS loan ALL instructional documentation to the individual as well. Compare the illustrations with your high power washer to familiarize yourself with the locations of various controls (Figure 1). Save this manual for future reference. Replacement owner’s manuals can be printed from the Generac Web site.
A - Spray Gun – Controls the application of water onto the cleaning surface with trigger device. Includes a trigger lock.
B - Lance with Quick Connect – Allows you to switch between four different nozzles.
C - High Pressure Hose – Connect one end to water pump and the other to the spray gun.
D - Recoil Starter – Use for starting the engine. E - Oil Fill – Check and add engine oil here.
F - Air Filter – Protects engine by filtering dust, and debris out of the intake air.
G - Pump – Develops high pressure.
H - Thermal Relief Valve – Cycle’s water through the pump when water reaches 125°F. Warm water will discharge from pump onto ground. This prevents internal pump damage.
I - Engine On/Off Switch – Run this switch to “ON” before using the recoil starter. Turn the switch to “OFF” to stop the engine.
J - Pressure Control/Unloader Valve – Controls the high pressure
output.
K - High Pressure Outlet – Connection for high pressure hose. L - Water Inlet – Connection for Garden Hose.
M - Fuel Tank – Fill tank with regular unleaded fuel. Always leave room for fuel expansion.
N - Fuel On/Off Switch – Turns fuel supply to the engine on and off.
O - Choke – Prepares a cold engine for starting.
P - Throttle Lever – Increases or decreases engine speed. Throttle should be at maximum travel when the pressure washer is in use.
Q - Nozzles – Chemical injection, 0°, 15°, 25°, 40° (white, yellow, red and black) for various high pressure cleaning applications.
R - Pull Pin – Pull the ring to unlock the handle. This allows the handle to be collapsed for storage.
S - Adjustable Side Handle – Adjustable by turning counter clockwise to loosen, adjust to comfortable position and tighten
T - Oil Drain – Drain engine oil here.
U - Serial Number Location
ITEMS NOT SHOWN
Identification Label (near rear of base plate) – Provides model and serial number of pressure washer. Please have these readily available if calling for assistance.
Detergent Siphoning Tube/Filter – Use to siphon pressure washer safe detergents into the low pressure stream.
Figure 1 – Features & Controls
| Q |
|
|
| C |
A |
|
|
|
| F |
|
| A |
S | M |
|
B |
| P |
|
| |
D |
| O |
|
| |
|
| J |
R |
| N |
|
| |
I |
| K |
|
| L |
|
| H |
|
| T |
|
| G |
| E | U |
|
|
4