Operator's Manual

Second Edition · Third Printing

 

 

 

 

OPERATING INSTRUCTIONS

Auto Level Outriggers (if equipped)

These instructions apply to machines with the black auto level outrigger control box.

1Position the machine below the desired work area.

2 Pull out the red Emergency Stop buttons at the ground and platform controls.

3Push and hold the auto level button.

4Activate the outrigger up/down toggle switch in the down direction.

Result: The outriggers will extend and level the machine. A beep will sound when the machine is level.

The red indicator light above the lift symbol on the outrigger control panel comes on when one but not all outriggers are down. All drive and lift functions are disabled.

The light turns off when all outriggers are in firm contact with the ground. The drive function is disabled while the outriggers are down.

To control individual outriggers

1 Push and hold the outrigger function enable button.

2 Push and hold an outrigger button.

3 Activate the outrigger up/down toggle switch in the desired direction to level the machine.

Positioning machine on a slope

When setting the machine up on a slope, the steer- end outriggers must be lowered first.

Fall Protection

Personal fall protection equipment (PFPE) is not required when operating this machine. If PFPE is required by job site or employer rules, the following shall apply:

All PFPE must comply with applicable governmental regulations and must be inspected and used in accordance with the manufacturer’s instructions.

24

Genie GS-2668 RT & Genie GS-3268 RT

Part No. 82233

Page 26
Image 26
Genie GS-2668 RT, GS-3268 RT manual Auto Level Outriggers if equipped, Fall Protection, To control individual outriggers