20 Genie Z-80/60 Part No. 82258
Operator's Manual First Edition · Third Printing
FUNCTION TESTS
Test Limited Drive Speed
63Press down the foot switch.
64Raise the primary boom to 10° above horizontal.
65Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom raised should not exceed
1 foot / 30 cm per second.
Note: The machine will travel 40 feet / 12 m in 40
seconds.
66Lower the primary boom to the stowed position.
67Extend the primary boom 4 feet / 1.2 m.
68Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom extended should not
exceed 1 foot / 30 cm per second.
Note: The machine will travel 40 feet / 12 m in 40
seconds.
69Retract the primary boom to the stowed position.
70Raise the secondary boom to 10° above
horizontal.
71Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the secondary boom raised should not
exceed 1 foot / 30 cm per second.
Note: The machine will travel 40 feet / 12 m in 40
seconds.
72Lower the secondary boom to the stowed
position.
If the drive speed with the primary or secondary
boom raised or the primary boom extended
exceeds 1 foot / 30 cm per second, immediately
tag and remove the machine from service.
Test Auxiliary Controls
73Push in the red Emergency Stop button to the
off position to shut off the engine.
74Pull out the red Emergency Stop button to
the on position.
75Press down the foot switch.
76Simultaneously press and hold the auxiliary
power button and activate each function control
handle, toggle switch or button.
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom and steer functions should
operate.