7.Re-plug cables to Control Module remove in step 2 and PowerPause connector to PowerPause Modules.

8.Re-install Control Module into transfer switch.

a.Line up Control Module to breaker bus stabs from where removed in step 1.

b.Hold at 30° angle, push onto bus stabs

c.Lower outside end flush with enclosure.

d.Slide Control Module ½” towards enclosure outside edge, lock into place.

e.Install (if required) circuit breaker opposite Control Module.

9.Route and dress wires in gutter of transfer switch enclosure.

22

Page 22
Image 22
GenTran ATS2001D, ATS2002R, ATS2001R, ATS1001R, ATS1001D manual