
English
Onboard LAN Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip. (Default: Disabled)
Onboard Serial Port 1
Enables or disables the first serial port and specifies its base I/O address and corresponding interrupt. Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.
Onboard Parallel Port
Enables or disables the onboard parallel port (LPT) and specifies its base I/O address and corresponding interrupt. Options are: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
Selects an operating mode for the onboard parallel (LPT) port. Options are: SPP (Standard Parallel Port)(default), EPP (Enhanced Parallel Port), ECP (Extended Capabilities Port), ECP+EPP.
ECP Mode Use DMA
Selects DMA channel for the LPT port in ECP mode. This item is configurable only if Parallel Port Mode is set to ECP or ECP+EPP mode. Options are: 3 (default), 1.
On-Chip USB
Configures the integrated USB controller.
V1.1+V2.0 | Enables the integrated USB 1.1 and USB 2.0 controllers. (Default) |
V1.1 | Enables only the integrated USB 1.1 controller. |
Disabled | Disables the integrated USB 1.1 and USB 2.0 controllers. |
Disabled will turn off all of the USB functionalities below.
USB Keyboard Support
Allows USB keyboard to be used in
USB Mouse Support
Allows USB mouse to be used in
Legacy USB storage detect
Determines whether to detect USB storage devices, including USB flash drives and USB hard drives during the POST. (Default: Enabled)
- 42 - |