Gigabyte GA-M52S-S3P user manual English, B Set Boot, N New Array ENTER Detail, R Rebuild

After that, the Array List screen appears, displaying the RAID array that you have created (Figure 7). (Note: BBS stands for BIOS Boot Specification. This indicates that the boot device is defined in the BIOS.)

MediaShield Utility Apr 20 2007

- Array List -

Boot	Status		Vendor	Array Model Name
BBS	Healthy		NVIDIA	STRIPE 223.57G
[Ctrl-X] Exit	[KL] Select	[B] Set Boot		[N] New Array [ENTER] Detail
			Figure 7

To read more information about the RAID array, press <Enter> to enter the Array Detail screen (Figure 8), which shows various information about the array, including the RAID mode, stripe block size, hard drive model name, and hard drive capacity, etc.

		Array 1: NVIDIA STRIPE 233.57G
		- Array Detail -
RAID Mode: Striped
Stripe Width : 2		Stripe Block: 64K
Port	Index	Disk Model	Capacity
1	0	ST3120026AS	111.79GB
2	1	ST3120026AS	111.79GB
	[R] Rebuild	[D] Delete [C] Clear MBR	[ENTER] Return
		Figure 8

To clear MBR, press <C> in the Array Detail screen. When the "Clear MBR?" message appears, press <Y> to clear or <N> to cancel.

To delete the array, press <D> in the Array Detail screen. When the "Delete array?" message appears, press <Y> to confirm or <N> to cancel. Press <Enter> to return to the Array List screen.

To exit the NVIDIA RAID setup utility, press <Esc> in the main menu or <Ctrl>+<X> in the Array List screen.

Now, you can proceed to the installation of the SATA controller driver and operating system.

- 73 - Appendix

English