SMART LAN (LAN Cable Diagnostic Function)
CMOS Setup
SMART LAN
Start detecting at Port |
|
|
|
|
|
| Item Help | ||
= | Open | / | Length | = | 0.0m |
| Menu Level` | ||
= | Open | / | Length | = | 0.0m |
|
|
| |
= | Open | / | Length | = | 0.0m |
|
|
| |
= | Open | / | Length | = | 0.0m |
|
|
| |
KLJI: Move | Enter: Select |
| F10: Save | ESC: Exit | F1: General Help | ||||
F5: Previous Values |
| F6: |
| F7: Optimized Defaults | |||||
This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN cable. This feature will detect cabling issue and report the approximate distance to the fault or short. Refer to the following information for diagnosing your LAN cable:
When No LAN Cable Is Attached...
If no LAN cable is attached to the motherboard, the Status fields of all four pairs of wires will show Open and the Length fields show 0.0m, as shown in the figure above.
When LAN Cable Is Functioning Normally...
If no cable problem is detected on the LAN cable connected to a Gigabit hub or a 10/100 Mbps hub, the following message will appear:
Start detecting at Port.....
Link Detected
Cable Length= 30m
Link Detected | Displays transmission speed |
Cable Length | Displays the approximate length of the attached LAN cable. |
Note: The Gigabit hub will only operate at a speed of 10/100 Mbps in
When a Cable Problem Occurs...
If a cable problem occurs on a specified pair of wires, the Status field will show Short and thenlength shown will be the approximate distance to the fault or short.
Example:
Explanation: A fault or short might occur at about 1.6m on Pair
Note: Pair
English
- 41 - | BIOS Setup |
