GN Netcom GN 6110 manual Pairing of headset to the base and verifying pairing

Pairing of headset to the base and verifying pairing

The headset and the base in their original product box have been factory-paired to ensure proper functioning of your GN 6110. You do not need to pair these two devices, and you may now proceed to the Clear dial tone adjustment section.

If original pairing is lost (by resetting the base, changing your headset or changing your base), you will have to pair your headset to the base again. You may also verify pairing between the headset and base at any point (except during telephone conversations). See Section 4.6 for these instructions.

Clear dial tone adjustment

Desk telephones operate on a range of standards. In order for your GN 6110 to work with your desk telephone and to hear a clear, crisp dial tone, you must set the correct dial tone setting. Consult the inside back cover of this user guide for the most common telephone models and settings.

Complete the following instructions to set the correct dial tone adjustment:

1.	Open the compartment cover on the bottom of the base and locate the	A
	termination switch [A].	G	F E DC	B	A
2.	Put on your headset and press the base’s Multifunction button. An audible
		B
		G F ED C

tone will shortly be heard.

3.Lift the telephone’s handset from the cradle and listen for a dial tone in your headset.

4.If there is no dial tone or it is not clear, stepwise slide the termination switch through all 7 settings (along the A-G range), listening for the clearest possible dial tone. If the dial tone is just as clear in position A as in position G, leave the switch in position A.

5.When you hear the clearest dial tone, you have located the correct termination setting.

Microphone volume adjustment

In order to ensure that your voice is neither too loud nor too soft when calling others, adjust the trans- mit sound volume. You will need to make a call with your desk telephone to adjust it.

Complete the following instructions to adjust the transmit volume:

1.	Open the compartment cover on the bottom of the base and locate the blue
	microphone volume adjustment button [A].
2.	Put on your headset and press the Multifunction Button on the base. An	B
		G F ED C
	audible tone will shortly be heard.
3.	Lift the telephone’s handset from the cradle and listen for a dial tone in your
	headset.
4.	Using your desk telephone, make a call to someone who will act as your test person.
5.	While speaking with your test person, adjust the blue microphone volume adjustment
	he/she hears your voice at an appropriate level.

A

button until

5

GN6110_contents_EU_07-11-03.indd 5 20-11-2003, 14:39:24