Installation
312900G 13
Select a Fluid Nozzle and Air Cap
The gun is supplied with Part No. 197266 Nozzle and
24A276 Air Cap. If you require a different size, refer to
Table1 and Table 2 , and instruction manual 309419, or
consult with your Graco distributor. See Replace Air
Cap/Nozzle on page 28.
A wide pattern kit (P/N 24A431) is included with the gun
and if installed, will provide more fan air for wider spray
patterns. (If pattern becomes split, use the fan air valve
to reduce the amount of fan air.)
NOTE: Due to the larger needle diameter, use a nozzle
one size larger than you would use with a standard Pro
Xs gun (i.e., 1.5 mm = 1.2 mm flow area).
* Glass-reinforced acetal construction.
*Also available in the following colors:
24A376 - gray
24A277 - red
24A278 - green
To reduce the risk of an injury, follow the Pressure
Relief procedure on page 19 before removing or
installing a fluid nozzle and/or air cap.

Table 1: Fluid Nozzles

Part No. Orifice Si ze
197265 1.2 mm (.047 in.)
197266 1.5 mm (.055 in.)
197267 1.8 mm (.070 in.)
249922* 1.2 mm (.047 in.)
249923* 1.5 mm (.055 in.)
249924* 1.8 mm (.070 in.)

Table 2: Air Caps

Part No.
Pattern Shape
and Length in.
(mm)
Recommended Fluids and
Production Rates
24A438 Round end;
15-17 (381-432)
Light to medium viscosity.
Up to 15 oz/min (450 cc/min)
24A279 Round end;
14-16 (356-406)
Medium to high viscosity and
high solids.
Up to 15 oz/min (450 cc/min)
24A276* Tapered end;
17-19 (432-483)
Light to medium viscosity.
Up to 15 oz/min (450 cc/min)
24A274 Tapered end;
12-14 (305-356)
Light to medium viscosity.
Up to 15 oz/min (450 cc/min)
24A439 Round end;
11-13 (279-330)
Medium to high viscosity and
high solids.
Up to 15 oz/min (450 cc/min)
For use with 2.0 mm nozzle.
24A275 Tapered end;
14-16 (356-406)
Light to medium viscosity and
high solids.
Aerospace coatings.
Up to 25 oz/min (750 cc/min).