Basic Spraying Techniques
NOTE: Use a piece of scrap cardboard to practice these basic spraying techniques before you begin spraying the surface. Anything you don’t want painted that is in the area of your spraying surface should be covered or removed.
Hold sprayer at least 10 in. (25 cm) from surface and adjust accordingly to achieve desired results. Aim sprayer straight at surface. Tilting sprayer to direct spray angle causes an uneven finish.
Basic Spraying Techniques
Triggering Sprayer
To achieve even spraying, pull trigger after starting the stroke. Release trigger before the end of the stroke. Sprayer must be moving when trigger is pulled and released.
(25 cm)
10 in.
thick
even finish
uneven
finish
thin
ti14780a
Start Moving | Pull Trigger | Release Trigger |
Flex your wrist while moving your arm to keep the sprayer pointed straight. Tilting the sprayer or spraying at an angle causes an uneven finish.
Even Finish | Thin | Thick | Thin |
|
|
|
|
NOTE: How fast you move the sprayer will affect spray application. If material is pulsating, you are moving too fast. If material drips, you are moving too slow. See Troubleshooting, page 20.
Aiming Sprayer
Aim tip of sprayer at bottom edge of previous stroke, overlapping each stroke by half.
14 | 3A0159E |
