Use only water-based or oil-based (mineral spirit-type) materials with flash point greater than 100° F (38° C). Do not use materials which state “FLAMMABLE” on the packaging. For more informa- tion about your material, request MSDS from distribu- tor or retailer.
Use oil-based material outdoors or in a well-ventilated indoor area with a flow of fresh air.
Keep spray area well-ventilated. Keep a good supply of fresh air moving through the area.
NOTICE
Your sprayer is NOT compatible with harsh cleaners such as chlorine bleach. Using these cleaners will cause damage to the sprayer.
Overheating Protection
This sprayer has a built-in protective device to prevent damage from overheating. The sprayer may automati- cally shut down after heavy use. If this happens, allow the sprayer to cool down for 20-30 minutes and resume spraying.
Installing Suction Tube
Aim the inlet of the suction tube at the front of the mate- rial cup (towards Spray Tip/Guard Assembly) during installation.
Spraying Stains or Clear Coats (Fine-Finish Optimizer)
The Fine-Finish Optimizer must be installed and used when spraying thin material (similar to water) such as stain or clear coats. The Fine-Finish Optimizer restricts the material flow resulting in a finer quality finish.
NOTICE
Failure to install the Fine-Finish Optimizer when using the NAR311 tip or when spraying thin materials will cause the motor to overheat and shutdown until it cools.
Installation
1. Remove material cup and suction tube.
2.Remove the cleaning tool before installing the Fine-finish Optimizer into the sprayer.
3.Push Fine-Finish Optimizer into pump inlet until completely engaged and re-install suction tube.
Cleanup/Storage
Be sure to remove and clean the Fine-Finish Optimizer immediately after use. Store the Fine-Finish Optimizer on the Storage/cleaning Tool supplied to keep the hole clear of dried material.
