Product Overview
HTX 2030 with Base Coat Pump (257369)
ti13632a
The HTX 2030 Sprayer comes equipped with a Base Coat Pump 24B321. Only
•Smooth to heavily aggregated textures with silica sand, perlite, vermiculite and polystyrene
•Smooth, medium, coarse and extra coarse textures
•Most materials with aggregates up to 2.5 mm (.100 in.) in longest dimension
When Base Coat Pump is Installed
Pump will only run when on/off switch is in ON position AND:
•Pump control is rotated clockwise away from OFF position, and either of the following switches are also switched ON:
Prime Switch on pressure control box AND/OR Applicator Switch near end of material hose
The pressure control will limit the sprayer to 1,000 psi (69 bar), stopping the pump whenever pressure limit is reached.
Product Overview
Flow rate is dependent on engine speed and the setting of the pump control knob.
1.Flow 3 (fully clockwise) - allows the pump to run continuously with minimal pulsation:
ti13756a
2.Flow 2 (near middle of the rotation) reduces flow slightly by briefly interrupting pump:
ti13757a
3.Flow 1 (near counterclockwise end of pump control) reduces flow more by interrupting pump longer:
ti13758a
4.OFF (fully counterclockwise) - stops pump com- pletely:
ti13755a
5.Adjust engine speed to control flow rate of sprayer. Start with the slowest speed possible for maximum spray control. Different spray tip nozzle sizes can also be tried.
ti5251a
313888E | 5 |
