Graco 3A1214B important safety instructions Setup, Charge Battery

Setup

Setup

Charge Battery

If the battery is newly purchased or has not been used for a long time, charge it before you use it.

Installing RoadLazer Into Vehicle

The RoadPak can be mounted in the front or rear of the vehicle bed as well as in any orientation desired. The base of the RoadPak is 39.5 in. x 49.5 in. (1.0m x 1.25m).

RoadLazer needs to be properly secured to prevent it from moving during transportation and operation.

Paint drums are heavy and could shift from side to side when the vehicle is cornering. The paint drums could fall from the vehicle and cause injury or death. Secure the drums when the vehicle is in transport or spraying.

Paint could splash from the paint drum bung adapters when the paint drums are full and the vehicle is mov- ing. Do not overfill the paint drums.

RoadPak Installation (24G624, 24G625)

Load RoadPak into vehicle using a forklift or a hoist that is rated for the weight capacity of the RoadPak. For RoadPak weight information see Technical Data, page 27.

ti16442a

ti16665a

ti16653a

ti16654a

ti16664a

After mounting the RoadPak on the vehicle, firmly secure the RoadPak to the vehicle using the tie-down brackets at all four corners, or by bolting the RoadPak through the bed of the truck to the frame in all four loca- tions.

ti16443a

ti16599a

8 3A1214B