Graco 3A2587H important safety instructions Overheating Protection, Sprayer Setup

Overheating Protection

Overheating Protection

The motor has a built-in feature to protect itself from overuse. If the motor stops, the thermal switch has tripped. Do not return sprayer to store. The motor will operate normally after cooling for 20-30 minutes.

For best results, do not spray more than one cup of water through the tip while cleaning. If more flushing is needed, remove the tip from the sprayer.

Sprayer Setup

Use only water-based or oil-based (mineral spirit-type) materials with flash point greater than 100° F (38° C). Do not use materials which state “FLAMMABLE” on the packaging. For more information about your material, request MSDS from distributor or retailer.

Use oil-based material outdoors or in a well-ventilated indoor area with a flow of fresh air.

Keep spray area well-ventilated. Keep a good supply of fresh air moving through the area.

NOTICE

Your sprayer is NOT compatible with harsh cleaners such as chlorine bleach. Using these cleaners will cause damage to the sprayer.

This sprayer arrives from the factory with a small amount of test material in the system. It is important that you flush this material from the sprayer before using it for the first time:

1.Fill material cup with water or compatible solvent, thread onto sprayer and hand tighten.

ti14992a

ti18915a

2.Put prime/spray valve to UP position, then hold trig- ger in for 10 seconds.

ti16700ati14999a

3. Put prime/spray valve DOWN to spray position.

ti16701a

ti15425a

4.Reverse spray tip to UNCLOG position and trigger sprayer into a waste area for 10 seconds.

ti15012a

ti14777ati15491a

5.Engage trigger lock and put prime/spray valve UP to release pressure.

	ti16700a
ti14994a	ti14999a
ti18912a

6.Unscrew and remove material cup.

7.Disengage trigger lock, hold sprayer slightly above material cup, and pull trigger to discharge fluid from pump.

ti18919a

8. Discard material in cup.

10 3A2587H