Shutdown and Cleaning
8.Disconnect trigger lock and trigger sprayer for approxi- mately 15 seconds. Engage trigger lock.
13.Engage trigger lock and put prime/spray valve UP to release pressure.
ti18913a | ti16716a | ti18912a |
9.Discard contaminated fluid and refill with appropriate flushing fluid.
10.Disengage trigger lock, reverse spray tip to UNCLOG position, and pull trigger for 5 seconds to prime sprayer.
ti18913a ti14995a
ti14777a ti14991a
11.Put prime/spray valve DOWN to spray position. Trigger sprayer into waste area until no paint appears in water or flushing fluid.
ti16701a ti15425a
ti15012a
IMPORTANT! For best results, do not spray more than one cup of water through the tip while cleaning. If more flushing is needed, remove the tip from the sprayer.
12. If sprayer is not completely clean, repeat steps
To avoid serious injury or damage to equipment, do not expose the sprayer electronics to flushing solvents. Keep sprayer at least 10 in. (25 cm) above the rim of the con- tainer when flushing.
ti15529ati18926a
Keep spray area
ti18912a | ti16700a |
|
ti14994a
NOTE: Air vent holes or the air vent valve (as your model is equipped) allow air to flow into the material cup while spraying to prevent loss of fluid flow.
14.Remove material cup and discard used fluid. Use a soft brush to clean the black rubber inlet seal. If vent holes become clogged, use a paper clip to clear the holes.
15.Remove spray tip/guard assembly and clean with water or flushing fluid. A soft brush can be used to loosen and remove dried material if needed.
ti15703a
ti15547a
ti15705a
NOTICE
The spray tip is permanently attached to the guard. Removing the spray tip from the guard will result in dam- age to the spray tip/guard assembly. Do not store spray tip/guard assembly or flexible suction tube in solvent other than mineral spirits. Damage to parts may occur.
16 | 3A2587H |
