Graco 3A2587H important safety instructions Storage, Cleaning Sprayer Exterior

Cleaning Sprayer Exterior

•Wipe paint off outside of sprayer using a soft cloth moistened with water or flushing fluid. Do NOT submerge the sprayer. Do NOT use solvents with a flash point greater than 100° F (38° C).

ti18922a

Storage

NOTICE

Failure to store sprayer with Pump Armor will result in operational problems the next time you spray. Always circulate Pump Armor through the sprayer after clean- ing. Water or solvents other than mineral spirits left in the sprayer will corrode and damage the pump.

1.Lift valve UP to the prime position. Remove material cup and flexible suction tube.

ti16700a

ti19034a ti18916a

2.Remove child-resistent cap. Thread nozzle onto Pump Armor bottle.

NOTE: For best results, make sure bottle is full.

ti18067a

Storage

3. Hold sprayer upside-down over a waste container.

ti19424a

4.Insert Pump Armor nozzle over material inlet and push firmly until it stops. Squeeze cleaning bottle until Pump Armor flows out drain tube.

ti18066a ti16700a

5.Remove Pump Armor nozzle and replace child-resistent cap and tighten securely for storage.

ti18069a

6.Attach flexible suction tube and material cup. Push valve DOWN to spray position.

ti16701a

ti19423a ti18915a

7.Store sprayer indoors in a cool, dry place. Store in an upright position only. Never store sprayer with material in the cup.

ti18921a

3A2587H 17