Install Spray Tip/Guard Assembly (if not installed)
This equipment stays pressurized until pressure is manually relieved. To help prevent serious injury from
Install Spray Tip/Guard Assembly (if not installed)
Getting Started with Basic Techniques
Use a piece of scrap cardboard to practice these basic spraying techniques before you begin spraying the surface.
•Hold sprayer 10 in. (25 cm) from surface and aim straight at surface. Tilting sprayer to direct spray angle causes an uneven finish.
pressurized fluid, such as skin injection, splashing fluid and moving parts, follow the Pressure Relief Procedure when you stop spraying and before cleaning, checking, or servicing the equipment.
1.Engage trigger lock and put prime/spray valve UP to release pressure.
(25 cm)
10 in.
even finish
thick |
|
| uneven |
thin | finish |
|
ti14780a
ti18923a
ti18912a | ti16700a |
2.Install spray tip filter to spray tip/guard assembly. NOTE: Spray tip filter is
Turn left (or
ti14775a 
ti15488a 
NOTICE
Make sure spray tip filter is completely screwed into the spray tip/guard assembly to avoid damage to the filter. Do not use a damaged spray tip filter or poor sprayer performance may result.
Do NOT place hands in front of tip.
3.Screw spray tip/guard assembly onto sprayer. Tighten retaining nut until completely engaged with sprayer. Do not overtighten nut.
•Flex wrist to keep sprayer pointed straight. Fanning sprayer to direct spray at angle causes uneven finish.
|
|
| even finish | thin | thick | thin | ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
ti14783a | ti14784a |
NOTE: How fast you move the sprayer will affect spray application. If material is pulsating, you are moving too fast. If material drips, you are moving too slow. See Trouble- shooting, page 24.
Triggering Sprayer
Pull trigger after starting stroke. Release trigger before end of stroke. Sprayer must be moving when trigger is pulled and released. 
ti14988a
ti14785a
Start Moving | Pull Trigger | Release Trigger |
ti14997a
ti15490a
NOTICE
The spray tip is a permanently attached to the spray tip/guard assembly. Removal will result in damage.
3A2587H | 13 |
