Graco ISPA109AC manual Using LATCH to install Base, restraint “Final Safety Check” p.40

6.4Using LATCH to install Base

1.	For ease of installation, extend LATCH	Tongue
	to its maximum length.
2.	Position base in vehicle seat as
	shown.
3.	Thread LATCH through base belt
	path normally used for vehicle
	seat belt. Make sure that LATCH is
	UNDER tongue on base .
	Belt must lay flat and not be twisted.
4.	Hook Connectors to vehicle lower
	anchors. Pull firmly on Connectors to
	be sure they are attached .
5.	Tighten LATCH by pushing down
	hard on base and pulling the
	adjustment belt .
6.	NEVER put two LATCH connectors on
	one vehicle LATCH anchor unless
	specifically allowed by the vehicle
	manufacturer .
7.	Test infant restraint for secure
	installation as described in infant
	restraint “Final Safety Check” p.40.

8.Check that the LATCH stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service.

37