Prime/Flush
1.See FIG. 8. To enter Prime/Flush mode, press any
key to wake up the display, then press 
. The Prime/Flush symbol will appear in the display and
the LED will flash |
| . |
|
|
|
2.While in Prime/Flush mode, runaway protection is disabled and the batch totalizer (BT) will not count. The grand totalizer (GT) continues to count.
3.To exit Prime/Flush mode, press any key to wake up
the display, then press 
. The Prime/Flush sym- bol will disappear from the display and the LED will stop flashing.
Counter/Totalizer
See FIG. 8. The last digit of the batch totalizer (BT) rep- resents tenths of gallons or liters. To reset the totalizer, press any key to wake up the display, then press and
hold 
for 3 seconds.
•If AC is set to gallons or ounces, BT and GT dis- play gallons.
•If AC is set to liters or cc, BT and GT display liters.
•If AC is set to cycles, BT and GT display cycles.
Press 
to toggle between flow rate units and cycles. A letter under the BT display indicates that both BT and GT are displaying gallons (g) or liters (l). No letter means both BT and GT are displaying cycles.
DataTrak Operation
Display
See FIG. 8. The display (AE) will turn off after 1 minute of inactivity in Run mode or 3 minutes in Setup mode. Press any key to wake up the display.
NOTE: DataTrak will continue to count cycles when dis- play is off.
NOTE: The display (AE) may turn off if a
Diagnostics
DataTrak can diagnose several problems with the pump. When the monitor detects a problem, the LED (AD, FIG.
8)will flash and a diagnostic code will appear on the dis- play. See Table 1.
To acknowledge the diagnosis and return to the normal
operating screen, press 
once to wake up the display, and once more to clear the diagnostic code screen.
313255F | 21 |
