INSTRUCTIONS FOR UPLOAD FROM LOCAL DIRECTORY
1.Download the firmware file from Grandstream web site
2.Unzip it and copy the file in to a folder in your PC
3.From the DP715 web interface (Advanced Settings page) you can browse your hard drive and select the folder where you previously saved the file.
4.Click “Upload Firmware” and wait few minutes until the new program is loaded.
Note: Always check the status page to see that the program version has changed.
INSTRUCTIONS FOR LOCAL FIRMWARE UPGRADE USING TFTP SERVER
1.Unzip the file and put all of them under the root directory of the TFTP server.
2.Put the PC running the TFTP server and the DP715 device in the same LAN segment.
3.Please go to File
4.Start the TFTP server, in the phone’s web configuration page
5.Configure the Firmware Server Path with the IP address of the PC
6.Update the change and reboot the unit
End users can also choose to download the free HTTP server from http://httpd.apache.org/ or use Microsoft IIS web server.
CONFIGURATION FILE DOWNLOAD
Grandstream SIP Device can be configured via Web Interface as well as via Configuration File through TFTP or HTTP/HTTPS. “Config Server Path” is the TFTP or HTTP/HTTPS server path for configuration file. It needs to be set to a valid URL, either in FQDN or IP address format. The “Config Server Path” can be same or different from the “Firmware Server Path”.
A configuration parameter is associated with each particular field in the web configuration page. A parameter consists of a Capital letter P and 1 to 3 (Could be extended to 4 in the future) digit numeric numbers. i.e., P2 is associated with “Admin Password” in the ADVANCED SETTINGS page. For a detailed parameter list, please refer to the corresponding firmware release configuration template.
When a Grandstream device boots up or reboots, it will issue a request for a configuration file “cfgxxxxxxxxxxxx”, where “xxxxxxxxxxxx” is the MAC address of the device, i.e., “cfg000b820102ab”. In addition, device will also requests a XML configuration file “cfgxxxxxxxxxxxx.xml”. If the download of “cfgxxxxxxxxxxxx.xml” is not successful, the provision program will issue a request for a generic configuration file “cfg.xml”. Configuration file name should be in lower case letters.
For more details on XML provisioning, please refer to:
http://www.grandstream.com/general/gs_provisioning_guide_public.pdf
FIRMWARE AND CONFIGURATION FILE PREFIX AND POSTFIX
Firmware Prefix and Postfix allows device to download the firmware name with the matching Prefix and Postfix. This makes it the possible to store ALL of the firmware with different version in one single directory.
Firmware version 1.0.0.23 | DP715/DP710 User Manual | Page 49 of 52 |
