Grandstream Networks DP710 manual Basic Operations, Understanding DP715/710 Voice Prompt

BASIC OPERATIONS

UNDERSTANDING DP715/710 VOICE PROMPT

DP715 Base Station has a built-in voice prompt menu for simple device configuration. The IVR menu work with any Handset registered to the base. Pick up the handset and dial “***” to use the IVR menu.

Table 9: DP715/710 IVR MENU DEFINITIONS

Menu	Voice Prompt	Options
Main Menu	“Enter a Menu Option”	Press “*” for the next menu option
		Press “#” to return to the main menu
		Enter 01-05, 07,10, 13-17,47 or 99 menu options
01	“DHCP Mode”,	Press “9” to toggle the selection
	“Static IP Mode”	If using “Static IP Mode”, configure the IP address information using
		menus 02 to 05.
		If using “Dynamic IP Mode”, all IP address information comes from
		the DHCP server automatically after reboot.
02	“IP Address “ + IP address	The current WAN IP address is announced
		If using “Static IP Mode”, enter 12 digit new IP address. You need to
		reboot the DP715 for the new IP address to take Effect.
03	“Subnet “ + IP address	Same as menu 02
04	“Gateway “ + IP address	Same as menu 02
05	“DNS Server “ + IP address	Same as menu 02
07	Preferred Vocoder	Press “9” to move to the next selection in the list:
		∙ PCM U / PCM A
		∙	iLBC
		∙	G-726
		∙	G-723
		∙	G-729
10	“MAC Address”	Announces the Mac address of the unit.
13	Firmware Server IP	Announces current Firmware Server IP address. Enter 12 digit new
	Address	IP address.
14	Configuration Server IP	Announces current Config Server Path IP address. Enter 12 digit
	Address	new IP address.
15	Upgrade Protocol	Upgrade protocol for firmware and configuration update. Press “9” to
		toggle between TFTP / HTTP / HTTPS
16	Firmware Version	Firmware version information.
17	Firmware Upgrade	Firmware upgrade mode. Press “9” to toggle among the following
		three options:
			- always check
			- check when pre/suffix changes
			- never upgrade
47	“Direct IP Calling”	Enter the target IP address to make a direct IP call, after dial tone.
		(See “Make a Direct IP Call”.)
86	Voice Mail	Number of Voice Mails
99	“RESET”	Press “9” to reboot the device
		Enter MAC address to restore factory default setting
		(See Restore Factory Default Setting section)
	“Invalid Entry”	Automatically returns to main menu

Firmware version 1.0.0.23 DP715/DP710 User Manual Page 27 of 52