![](/images/new-backgrounds/1099841/9984123x1.webp)
OPERATING
MX20100
a. Loosen jam nuts (D) and adjust nuts (E) on each
b. Tighten jam nuts (D).
Checking Level (Front-to-Rear)
1. Set
NOTE: The height of the rear blade tip should be between
MX20122
2.Position right mower blade (F) (discharge side) parallel to the direction of travel.
3.Measure distance (G) from front blade tip to the ground.
4.Turn blade 180° and measure from rear blade tip to the ground.
5.If the
Adjusting Level
c
IMPORTANT: Avoid damage: Adjust the left and right deck lift assist rods equally.
NOTE: Adjust
Adjust both sides of the mower deck equally. All lift chains must remain taut.
MX20099
1.Loosen jam nut (H) on both deck lift assist rods.
2.Adjust
•Turn nut (I) on both sides clockwise to raise front of mower deck, or counterclockwise to lower front of mower deck.
3.Verify that the adjustment on right and left sides is equal.
4.Tighten jam nuts (H).
5.Check
Checking and Adjusting Cutting Height
c
CAUTION: Avoid injury! Rotating blades are dangerous. Before adjusting or servicing mower:
•Disconnect spark plug wire(s) or battery negative
•Always wear gloves when handling mower blades or working near blades.
Checking Overall Cutting Height
1.Inflate tires to correct pressure.
2.Lower mower deck to the 76 mm (3 in.) cutting height.
3.Position right mower blade (discharge side) parallel to the direction of travel.
4.Measure from the front of the blade tip to the ground.
5.If blade tip height is not within
Operating - 10