Greenheck Fan GGH20 manual Electrical, Detergent Tank Installation, Detergent Requirements

Detergent Tank Installation

The detergent tank is located as shown in the photo. When installing the detergent tank, the low detergent indicator float and the detergent pump inlet tubing will need to be lifted. Once the tank is in position, the low detergent indicator float and detergent inlet tube must be lowered into place inside the tank.

A.One-inch unions

B.Detergent tank

C.Mounting plate

D.Isolators (qty of four)

E.Detergent pump

Detergent Requirements

The detergent brand Formula G-510 (by 2010 Products, Inc.) is recommended by Greenheck for use in the wash system. Use Formula G-510 full strength. This product is biodegradable, non-caustic, and safe for kitchen staff to use. If G-510 detergent is not used, the cleanliness of the exhaust plenum and filters cannot be guaranteed.

Preventative Maintenance

The following practices will prolong the life of the detergent pump:

•Keep detergent tank filled.

•Avoid spilling detergent on the exterior of the pump.

•Clean the detergent tank at least every six months.

•Clean the detergent line strainer at least every six months.

•Check tightness of all fittings periodically.

The detergent pump motor has sealed bearings which do not require lubrication.

NOTE

G-510 is manufactured by 2010 Products, Inc., Food Service Division, Salem, Oregon 97303. For details and ordering information, call 800-286-2010.

Electrical

Electrical Wiring

All wiring must be done according to NEC (National Electrical Code NFPA #70) and local building codes. Two sources of power need to be brought into

the electrical control cabinet. A 120 volt, 30 amp service with 12 gauge wire needs to be connected to terminals L1 on the disconnect switch and N. A 120 volt, 15 amp service with 14 gauge wire needs to be brought into the electrical cabinet and connected to terminal L2 on the disconnect switch and N1.

NOTE

The wash control station will provide a dry contact for a fan starter so the fans can be controlled by the PLC. The fan starter is not provided with the wash control station.

The main recirculating pump needs to be wired after it is installed in the hood. There are three 12 gauge wires in flexible conduit wired to the pump. Wiring to the pump is complete from the factory. The whip from the pump needs to be wired into the control cabinet.

®

Model GGH2O 17