Installing Backsplash Panels

Flat backsplash panel

Material gauge – Stainless

Wall

Heigth

Length

NOTE

Panels up to 47 inches (119.4 cm) wide ship in one piece. Over 47 inches (119.4 cm) in multiple pieces.

1.After the hood is hung in position, slide the flat flange of the backsplash panel behind the back of the hood.

Note: If the backsplash panel length is greater than 45 in. (114.3 cm), it will be shipped in multiple pieces.

2.After the backsplash panel has been positioned, drill holes in the panel and fasten to the wall. (Fasteners provided by others).

Note: The holes should be spaced to adequately secure the panel to the wall.

3.Caulk the joints between the hood and the backsplash panel with NSF Approved silicone caulk (GE SCS1000, or its equivalent). The caulk is not provided.

4.Caulk the joint between the backsplash panels when multiple panels are required, with NSF Approved silicone caulk (GE SCS1000, or its equivalent). The caulk is not provided.

Hood End Panel

Hood Front Panel

 

Insulated backsplash panel

Material gauge – Stainless

Insulation – 1 inch (25.4 mm)

1 inch (25.4 mm)

Wall

Height

Length

NOTE

Panels up to 45 inches (114.3 cm) wide ship in one piece. Over 45 inches (114.3 cm) in multiple pieces.

Slide flange behind back of the hood.

Backsplash Panel

Section view of backsplash panel overlap

Holes should be spaced to adequately secure the panel to the wall studs. (Hole spacing and fasteners provided by others).

14 Model GGH2O

®

Page 14
Image 14
Greenheck Fan GGH20 manual Installing Backsplash Panels, Flat backsplash panel Material gauge Stainless