Grindmaster APBIC-430V2 A530-066 Control Board, Troubleshooting cont, Brewing Problems, Remedy

Troubleshooting (cont.)

Brewing Problems

Problem	Possible Causes	Service Check	Remedy
Brew cycle will	• Controller faulty.	• Check to see that the	• If there is not 24 Vac across
not start		power is supplied to the	brew valve, replace control
		controller by following	board.
		instructions given in
		the Troubleshooting
		section on Filling
		Problems. Once
		touchpad and momentary
		switch integrity is
		assured (see above),
		initiate a brew cycle
		and check for 24 Vac
		across brew valve.
Sprayhead will not	• Brew valve not closing	• Visually inspect brew	• Clean lime from valve. Seat,
stop dripping water	completely.	valve at hose	cup or entire valve may need
		connections.	replacement.
	• Water in tank boiling.	• Remove sprayhead	• Reduce tank temperature.
		and determine if drip is
		coming from overflow.

If you still need help, call our Service Department at (800) 695-4500 (USA and Canada only) or (502) 425-4776 (Monday-Friday 8:00 am - 6:00 pm EST) or an authorized service center in your area. Please have the model and serial number ready so that accurate information can be given.

Prior authorization must be obtained from Grindmaster-Cecilware’s Technical Services Department for all warranty claims.

A530-066 Control Board

used on all PrecisionBrew™ V2.0 models

Refers to software version number.

Subject to change.

Page 26 Shuttle Brewers & Airpot/Shuttle Brewers