Grindmaster G & MG Series Dispensing Product, Adjustments, Consistency Adjustment, Page

Dispensing Product

To dispense the product, position the cup under the dispensing valve (C) and lower the dispensing lever (B) (see fig. O).

!Attention: If the machine is turned off at night, with the bowls filled, or just partially filled, a layer of solid ice may form on the surface due to the natural separation of the unmixed (non-moving) product. In this case, before turning the machine back on, remove the layer of superficial ice to prevent damage to the mixing auger.

Adjustments

!Attention: To prevent the product from becoming too thick, it is necessary to push left “Press To Select Function” and right “Press To Select Function” keys to cold drink position or to refill the bowl when the level of the granita inside the bowl is below the minimum fill line.

Consistency Adjustment

1.) Unplug the machine.

2.) Be sure that product in bowl is within proper fill range.(Above the minimum fill line)

3.) Remove merchandiser.

4.) Change the thickness of the product by turning the screw (D) on the back of the bowl, as shown on fig. P. Turn the screw clockwise for thinner product or counterclockwise for thicker product. The indicator gauge (D1), located on the back of the bowl, shows the degree of adjustment (+/-). (+) = thicker, (-) = thinner

Note: This (D1) is an indicator gauge only. To adjust consistency, turn screw on top (D).

(Figure O)

(Figure P)

(Figure Q)

Page 8 G & MG Series Granita Machine