Setting Defrost Timer (Night Setting) (cont.):
5.) Then press the “Auto Timer” clock button to set the minutes to complete time setting that you want it to turn to refrigeration mode, (defrost mode). Then press the “Press To Select Function” button to save the setting.
6.) Proceed to setting the time you want the machine to turn to freezing mode by following steps 4 and above. Then press the “Press To Select Function” button to save the time settings for freeze mode. Freeze light should be blinking.
Note: Once the settings have been saved, the unit will save the settings, even when the power switch is turned OFF.
When the light on the “Auto Timer” clock button is “on”, the defrost timer is activated. To turn OFF the defrost timer, press the “Auto Timer” clock button(s) until the light(s) on the clock button(s) turns off.
Operate in Automatic Mode (with Defrost Timer Activated):
1.) Turn power switch ON and wait for LED to light up.
2.) Press auger button “ON” for the side you are setting.
3.) To operate in defrost mode press the “Auto Timer” button until it is illuminated.
4.) When setting automatic times, please keep in mind it will take time for the frozen product to become liquid or vice versa.
Operate in Manual Mode (without Defrost Timer Activated):
1.) Turn power switch ON and wait for LED to light up.
2.) Make sure clock button is OFF (LED light on clock button should not be lit up).
3.) First turn auger on by pressing “Auger ON/OFF” button until it beeps. (Note: The auger must be on before unit will allow the cooling or freezing mode to activate)
4.) Then select refrigeration or freezing mode by pressing the “Press To Select Function” button until the light under the selection you desire is lit up. (Note: In the cooling mode, the LED will read the actual temperature of the product {The temperature setting is preset to NSF standards and is not adjustable.}) In the freezing mode the LED will read the current time.
G SERIES MODELS - ERROR MESSAGES
1.) “FILTER CLEANING” ALARM
A filter cleaning alarm will activate when the unit is running hot due to insufficient internal air circulation.
When this occurs a “Filtr” message will appear on the touchpad LED readout and an intermittent audible tone will also sound to alert the operator of this condition.
The “Filtr” message will appear when the alarm activates (a beeping sound every
•Condition: The filter is dirty and needs to be cleaned. - Corrective Action: Clean and replace filter following instructions on page 11 (Removing and Cleaning Filter).
•Condition: The unit is positioned too close to a wall or other object restricting air flow and causing the
machine to run at a higher temperature. - Corrective Action: Reposition unit to maximize ventilation space (see page 2 - installation figures).
•Condition: The filter is not properly installed. - Corrective Action: Properly install filter see “Removing and cleaning filter” page 11.
•Condition: The unit has been installed near a heat source, such as a coffee machine, ice maker or cold beverage machine which expels hot air from its vents, causing the machine to run at a high temperature. (Installation near a heat source should be avoided) - Corrective Action: Reposition unit to maximize ventila- tion space (see page 2 - installation figures).
Page 6 | G & MG Series Granita Machine |
