Grindmaster G & MG Series instruction manual Preparing Product, Operating Panel

(Figure K)

Preparing Product

!Attention: Make sure that the mixture has a 13% minimum Brix (sugar content). A lower concentrate could seriously damage the mixing parts, as well as the gear motors. NEVER USE ONLY WATER.

1.) If using product concentrate (instead of ready-to-use product), dilute and mix the prod- uct with water, according to the directions given by the manufacturer, in a separate container (see fig. I). Never pour dry powder, crystals, or concentrate into a dry bowl.

2.) Slide the merchandising lid either forward or toward the back of the bowl until the “stops” reach the edge of the bowl. (It is not necessary to remove the merchandis- ing cover.) When sliding lid back make sure that no droplets of water come off lid. Pour the prepared product into the bowl (see fig. J). Do not spill any material on lid or on bowl. There is a minimum and maximum fill line on the bowl. Do not overfill

or run the unit without enough product. Running unit with product below the minimum full line may cause damage to the unit.

3.) Insert the plug into a dedicated electrical outlet.

Operating Panel

(Figure I)

(Figure J)

In order to access the operating panel, lower the cover (A) as shown

in figure K. To lower the cover use a coin or other object to turn the keyless lock to the horizontal position.

Operating Panel -Electronic Touchpad

Auger ON/OFF

Press To Select Function

LED

COLDCOLD

AUGER ON/OFF

FROZENFROZEN

PRESS TO SELECT

FUNCTION

OFFOFF

ON

OFF

AUTO TIMER AUTO TIMER

(Figure L)

Programming G Series Electronic Touchpad Models

Models G23-2B, G235-2B & G236-2B Electronic Touchpad:

Main Power Switch:

1.) Turns unit ON.

2.) Selects 12/24 time or FÞ/CÞ temperature display when turned ON while simultaneously depressing the auger button.

3.) Sets current time when turned ON while simultaneously depressing the “Mode/Press To Select Function” button.

Page 4 G & MG Series Granita Machine