Cleaning and Sanitizing Procedures
!Warning Disconnect the unit from its power supply prior to cleaning or sanitizing the unit. Failure to do so may result in electric shock.
Daily Cleaning
For the machine to function properly, it is important that the cleaning procedures be carried out daily, according to the following instructions:
1.) Turn off the
/
(G, fig. M) refrigeration and 
/
(F, fig. M) freezing switches and empty the bowl of its remaining product; after draining the prod- uct from the unit, you can fill the bowl with hot water (not boiling) to help melt off any sugar deposits. Then drain the water prior to proceeding to step (2).
2.) Unplug the unit.
3)Pull out the mixing rod (E) by pushing it slightly backwards to remove it from its position (see fig. Q on pg.8).
4.) Unscrew and remove the two knobs (F) then lower the bowl to drain out any remaining product through the dispensing valve (see fig. R).
5.) Remove and disassemble the dispensing valve:
•Remove the pin (G) as shown (see fig. S).
Then, remove the handle (B) sliding it from its seat.
•Simultaneously apply pressure to the two securing tabs (H) and lift the dispensing valve (C) to pull it out of its position (see fig. T).
6.) Remove the bowl (L) by unscrewing the two knobs (F) and pulling it downwards as shown in fig. U.
7.) Unscrew the securing bolt (M) clockwise. Pull off the auger (N) and remove the shaft seal (O) and the bowl seal (P) (see fig. V).
8.) Remove the drain tray by lifting up on the front edge, while lowering the rear edge, and then lift it off the unit (see fig. W).
9.) Thoroughly wash each part that has been removed in steps
(Q), as well as the freezing cylinder (R) with warm water and mild dish- washing detergent. Rinse well with clear water and allow to air dry (see fig. X). Avoid the use of abrasive cleaners which can damage the finish. Do not put in dishwasher. Dishwasher may damage some parts such as the clear plastic auger gears and top mixing bar. Reassemble with clean hands.
(Figure R)
(Figure S)
(Figure T)
(Figure U)
(Figure V)
(Figure W)
(Figure X)
G & MG Series Granita Machine | Page 9 |
