Placing Sander
The Model G0449/G0450 has a shipping weight of 1190/1275 lbs. Serious personalinjurymayoccur if safe moving meth- ods are not followed. To be safe, get assistance and use power equip- ment when moving the crate and removing the machine from the crate.
Use lifting straps with a combined minimum of 1500 lbs. lifting capacity. If lifting straps break, serious personal injury may occur.
To place the sander in a permanent location:
1.Unbolt the sander from the pallet.
2.Position the forklift forks directly above the sander. Place two lifting straps with hooks on the ends over the forklift forks and slide the hooks into the points shown in Figure 9.
Figure 9. Lifting the sander.
3.Lift the sander and move it to your predeter- mined location. DO NOT lift it any higher than is necessary to clear the floor.
G0449/G0450 37" Drum Sander
Mounting to Floor
Although not required, we recommend that you mount your new machine to the floor. Because this is an optional step and floor materials may vary, floor mounting hardware is not included.
Bolting to Wood Floors
The most secure method of mounting this drum sander to a wood floor is using 3⁄8" hex bolts with flat washers, and securing the bolts from under the floor with flat washers, lock washers and hex nuts. Use lag bolts with washers only if you do not have access to the underside of the floor.
Bolting to Concrete Floors
Lag shield anchors with 3⁄8" lag bolts or anchor studs (Figure 10) are two popular methods for anchoring an object to a concrete floor. We sug- gest you research the many options and methods for mounting your machine and choose the best that fits your specific application.
Figure 10. Concrete anchor options.
NOTICE
Concrete anchor studs are stronger and more permanent alternatives to lag shield anchors; however, they will stick out of the floor, causing a tripping hazard if you decide to move your machine at a later point.
