Grizzly G0512 Attaching Dust Port, Connecting Plug to Cord, To attach the dust port

Attaching Dust Port

To attach the dust port:

1.Attach the dust port to the support brackets with the three 5⁄16"-18 x 1⁄2" hex bolts and washers, as shown in Figure 9, but DO NOT completely tighten the bolts yet.

Figure 9. Dust port attached to brackets.

2.Position the dust port approximately 1⁄2" away from the driver roller and tighten the two attachment bolts from step 1.

Connecting Plug to

Cord

The voltage you decide to use with your sander will determine which plug and receptacle you install. Read pages 6 & 7, in Section 3: Circuit Requirements for more information.

Install the plug and receptacle now.

-14- G0512 Edge Sander