SECTION 8: SERVICE ADJUSTMENTS

Disconnect power to the machine when perform- ing any adjustments or maintenance. Failure to do this may result in seri- ous personal injury.

About Service

This section is designed to help the operator with adjustments that were made at the factory and might also need to be made during the life of the machine.

This section is provided for your convenience—it is not a substitute for the Grizzly Service Department. If any adjustments arise that are not described in this manual, then feel free to call the Grizzly Service Department.

Similarly, if you are unsure of how to perform any procedure in this section, the Grizzly Service Department will be happy to guide you through the procedures or help in any other way.

Adjusting Tensioner

The belt tensioner is normally adjusted as the belt stretches. Two good indications of belt stretch (or a loose belt) are if the belt slaps against the plat- en while running or if it slips on the rollers.

On the other hand, if the belt tension is too tight, you will have a hard time installing and removing the belt when the belt tension is released.

To adjust the belt tensioner:

1.Disconnect the sander from the power source!

2.Lower the table as far as it will go.

3.Loosen the tracking lock knob, release the belt tension, and remove the sanding belt from the sander.

4.Move the belt tension lever to the position where the belt is normally tensioned.

5.Locate the belt tension nut and the tracking control bolt shown in Figure 35.

Tracking

Control Bolt

Tension

Nut

Figure 35. Belt tension nut and tracking

control bolt.

-24-

G0512 Edge Sander

Page 26
Image 26
Grizzly G0512 instruction manual Service Adjustments, About Service, Adjusting Tensioner