Grizzly G0512 Installing Roller Guard, Test Run & Tracking, To install the roller guard

Installing Roller

Guard

To install the roller guard:

1.Place the guard on top of the idler roller and secure it in position with the included small star knob, as shown in Figure 10.

Figure 10. Idler roller guard installed and secured in position with small star knob.

Test Run & Tracking

Before you can install the table, you must run the sander to track the belt. However, you should perform a “pre-tracking” procedure before starting the sander to ensure that the belt does not come off of or bottom out on the rollers during the initial startup.

To pretrack the belt:

1.Make sure that the sander is disconnect- ed from the power!

2.Loosen the tracking lock knob.

3.Standing in front of the sander, push the sanding belt multiple times along the platen, so that it moves in the direction of operation (counter-clockwise on the rollers), and watch how the belt tracks on the rollers.

4.Adjust the tracking higher or lower as need- ed and continue to rotate the belt by hand.

5.Repeat steps 3 & 4 until the top of the sand- ing belt rides even with the top of the main roller as shown in Figure 11.

Figure 11. Sanding belt even with

top of main roller.

G0512 Edge Sander -15-