Grizzly G0524 owner manual Fence Ride Height, To adjust the ride height of the fence

To adjust the feed motor V-belt tension:

1.Disconnect the saw from the power source!

2.Remove the side access panel to reveal the adjustment mechanism.

3.Loosen the jam nut (Figure 30).

Jam Nut

Adjustment

Nut

Figure 30. Feed motor V-belt adjustment.

4. Raise or lower the adjustment nut to change the V-belt tension. Note—Raise the adjust- ment nut to decrease the tension and lower it to increase the tension.

5. Retighten the jam nut when the V-belt has been tensioned correctly and re-install the side access panel.

Fence Ride Height

To adjust the ride height of the fence:

Adjust the setscrew (Figure 31) to raise and lower the ride height of the fence. Note—The fence could scratch the cast iron table surface if the ride height is set too low.

Figure 31. Fence ride height adjustment.

G0524 Rip Saw -29-