|
| Lube System |
|
|
|
|
|
|
Inspect
Bearings
The sealed ball bearings in this machine are permanently sealed and lubricated. There is no need to lubricate them. If the bearing wears out, simply replace it with one ordered from our ser- vice department.
The lube reservoir (Figure 25) houses the oil that lubricates the conveyor track. The oil is pumped through a series of plastic tubes at a rate of
ccevery 5 minutes, and onto a brush under the main table. When the oil level in the reservoir becomes low, a switch is triggered that prevents the saw from being operated. If this occurs, fill the reservoir above the “low” line and the saw will operate normally.
Figure 25. Lube reservoir.
G0524 Rip Saw |
