Laser Guide with Arm - H5749

Improve rip cutting accuracy, work more efficient- ly, and increase yields with the optional Grizzly H5749 Laser Guide. This bolt-on accessory is perfect for production shop looking to make the most of their Grizzly G0524 Rip Saw.

Inventory

Qty

Steel Arm

1

Laser Bracket

1

Laser Clamp

1

Laser

1

Power Box

1

Cap Screws M8-1.25 x 25

4

Flat Washers 8mm

4

Lock Washers 8mm

4

Cap Screws M6-1 x 16

2

Flat Washers 6mm

2

Cap Screws M6-1 x 35

2

Phillips Head Screws M5-.8 x 8

2

To install the laser guide on the Model G0524 Rip Saw:

1.Disconnect the Model G0524 Rip Saw from the power source!

2.Attach the steel arm to the head casting with the (4) M8-1.25 x 25 cap screws, (4) 8mm flat washers, and (4) M8 lock wash- ers. Note—The mounting location and drill pattern for the steel arm are shown on page 46. The holes must be drilled and tapped to accept M8-1.25 threads.

3.Mount the laser bracket to the top of the steel arm with the (2) M6-1 x 16 cap screws and

(2) 6mm flat washers.

4.Place the laser clamp around the laser and secure the assembly to the laser bracket with the (2) M6-1 x 35 cap screws.

5.Attach the black power box to the rip saw with the (2) M5-8 x 8 Phillips head screws. Note—Make sure the loose end of the green ground wire is secured between the head of the Phillips screw and the black power box.

6.Route the power wires from the power box through the side of the saw base and into the electrical panel compartment.

7.Connect the R1 and T1 power wires to their respective R1 and T1 locations on the main terminal at the electrical panel.

8.Feed the laser power wire through the access holes on the steel arm, and plug the power wire into the back of the power box.

9.Cut a board, turn the saw OFF, place the board against the fence, and finally, adjust the laser beam along the freshly cut edge.

DO NOT look into the end of the laser. Serious eye damage will occur.

Power Box

Steel Arm

Placement

Laser

Clamp

Laser

Bracket

Laser

Figure 1. Model H5749 Laser Guide.

Figure 2. Electrical wiring.

-34-

G0524 Rip Saw

Page 36
Image 36
Grizzly G0524 owner manual Laser Guide with Arm H5749, Inventory Qty