Grizzly G0560 Stand, Components and Hardware Needed Qty, Tools Needed, To assemble the stand

Stand
Components and Hardware Needed:	Qty
Rubber Feet	4
Feet Bracket	4
Hex Bolt M6-1 x 20	4
Stand Side	2
Stand Side Brace	2
Stand Top	1
Top Panel “S” Brace	1
Motor Mounting Bracket	1
Carriage Bolt M8-1.25 x 16	16
Hex Nut M8-1.25	20
Flat Washer 8mm	20
Tools Needed:
10mm Wrench or Socket	2
To assemble the stand:

All stand pieces except the rubber feet should be assembled with the M8-1.25 x 16 carriage bolts, M8 hex nuts, and 8mm washers.

1.Attach the stand sides to the stand top as shown in Figure 7. Make sure the side of the stand with the switch cutout is on the same side as the V-belt cutout on the top piece. This will ensure that the switch is in front of the bandsaw. Do not completely tighten the carriage bolt nuts at this time.

Switch Cutout

V-belt Cutout

Figure 7. Stand sides attached to stand top.

2.Place the (4) feet brackets on the stand cor- ners where the rubber feet will be installed.

3.Insert the (4) M6-1 x 20 hex bolts into the rubber feet and attach the feet to the stand corners as shown in Figure 8.

Rubber Foot

Foot Bracket

Figure 8. Rubber foot and foot brackets.

4.Attach the side braces to the stand sides as shown in Figure 9.

Side Braces

Figure 9. Stand braces attached to stand sides.

G0560 Meat-Cutting Bandsaw -13-