Stand Covers |
|
Components and Hardware Needed: | Qty |
Tap Screws #6 x 3⁄8" | 12 |
Catch Tabs | 12 |
Stand Covers | 2 |
Tools Needed: |
|
Phillips Head Screwdriver | 1 |
The stand covers need catch tabs installed in all the predrilled holes as shown in Figure 17 & 18.
Figure 17. Stand covers with catch tabs.
Figure 18. Catch tab in place on stand cover.
The stand covers fit inside the stand openings and attach by turning the catch tabs over the edges of the stand.
Blade & Table |
|
Guards |
|
The blade and table guards prevent contami- | |
nants from falling into the saw. |
|
Components and Hardware Needed: | Qty |
Blade Guard | 1 |
Table Guard | 1 |
Knob Screw | 6 |
To install the guards: |
|
1.Place the table guard around the bandsaw throat on the top edge as shown in Figure 19.
Figure 19. Table guard installed.
2.Secure the table guard in place with a knob screw on each side of the guard.
3.Place the blade guard around the side of the bandsaw covering the blade as shown in Figure 20.
|
|
|
|
|
|
|
|
|
|
|
|
G0560 | |||
