Grizzly G0560 instruction manual Bandsaw Unit, Belt, To put on the V-belt

Bandsaw Unit
Components and Hardware Needed:	Qty
Bandsaw Base Unit	1
Special Hex Bolt M10-1.5 x 16	3

The Model G0529

weighs 127 lbs. Personal injury could occur if the machine is moved without addition- al assistance. Seek help when moving or lifting the machine.

To install the bandsaw unit onto the stand:

1.Place the bandsaw base unit onto the stand as shown in Figure 15. Get help so you do not strain yourself.

Figure 15. Bandsaw unit on stand.

2.Line up the holes in the corner of the stand with the holes on the bottom of the bandsaw unit.

3.Fasten the stand to the bandsaw unit with the (3) M10-1.5 x 16 special hex bolt as shown in Figure 16.

Figure 16. Installing special hex bolt.

V-Belt

Before you put on the V-belt, make sure that the motor pulley and the upper pulley are reasonably aligned. To do this, loosen the setscrew on the motor pulley, adjust the motor pulley so it is in-line with the upper pulley, then tighten the setscrew.

To put on the V-belt:

1.Loosen the (4) motor mount bolts.

2.Raise the motor up and fit the V-belt in the pulley grooves, then let the motor down.

3.Place slight pressure on the motor to tension the belt and tighten the (4) motor mount bolts. Make sure that the motor does not twist and double check the pulley alignment. Adjust the positioning as needed.

4.Check for approximately 1⁄4" deflection. If the belt is not tensioned correctly, repeat steps 1 and 3 until it is correct.

-16- G0560 Meat-Cutting Bandsaw