MotorWiring

Components and Hardware Needed:

Qty

Motor

1

Hex Bolt M8-1.25 x 20

4

Hex Nut M 8-1.25

4

Flat Washer 8mm

8

Tools Needed:

 

Wrench or Socket 10mm

1

To install the motor:

 

1.Place the motor on the mounting plate so the motor pulley is directly under the pulley slot in the top of the stand.

2.Fasten the motor onto the motor mount (as shown in Figure 13) with the hex bolts, hex nuts, lock washers and flat washers. The washers should be placed on both sides of the motor mount.

Figure 13. Motor mounted to motor mount.

The diagram in Figure 14 shows the proper wiring of the motor and the power cord. The ground wires mount underneath the switch with the 10-24 x 12" Phillips screw, nut and star wash- er. Do not pinch the wires while installing them. If they will not reach, carefully cut back the outer layer of the black cord. Do not cut insulation on the smaller wires inside!

Figure 14. Wiring to switch plate.

After everything is wired correctly, take off the nuts that hold the switch over the mounting hole in the stand. Slide the rubber cover over the back of the switch so no metal contacts are exposed. Push the mounting screws through the holes on the ends of the cover and thread the nuts back on the screws. Tighten them securely, but not tight enough to ruin the rubber.

 

 

 

 

 

 

 

 

 

 

 

 

G0560 Meat-Cutting Bandsaw

-15-

Page 17
Image 17
Grizzly G0560 instruction manual MotorWiring, To install the motor