Grizzly G0591, G0588 owner manual Crosscut Table, Crosscut Fence, To install the crosscut table

Crosscut Table
Components and Hardware Needed:	Qty
Crosscut Table	1
Crosscut Table Lock Plate	1
Adjustable Handles M10-1.5	1
Flat Washers 10mm	2
To install the crosscut table:

1.Thread the adjustable handles, with 10mm flat washers, two or three turns onto the studs in the lock plate.

2.Slide the lock plate into the T-slot in the side of the sliding table.

3.With the help of an assistant, place the crosscut table on the pivot pin of the swing arm and over the studs of the lock plate (see Figure 42).

Figure 42. Installing the crosscut table.

4.Insert the indexing blocks into the T-slot and lock the crosscut table in place with the adjust levers.

-30-

Crosscut Fence
Components and Hardware Needed:	Qty
Crosscut Aluminium Fence	1
Lock Knobs M10-1.5	2
Flip Stops	2

To install the crosscut fence:

1.Insert the T-bolts in the places indicated in Figure 43.

T-Bolt

Placement

Figure 43. Crosscut fence placement.

2.Place a framing square along the edge of the sliding table and use the crosscut fence adjustment screw (Figure 44) to align the fence perpendicular to the sliding table.

Note: Follow the instructions on Page 48 to make the fence perfectly perpendicular.

Figure 44. Crosscut fence adjustment screw.

G0588/G0591 12" Sliding Table Saws