SECTION 7: SERVICE
Always disconnect power to the machine before performing ser- vice adjustments. Failure to do this may result in serious personal injury.
About Service
This section is designed to help the operator with adjustments that were made at the factory and that might also need to be made during the life of the machine.
This section is provided for your convenience— it is not a substitute for the Grizzly Service Department. If any adjustments arise that are not described in this manual, then feel free to call the Grizzly Service Department at (570)
Similarly, if you are unsure of how to perform any procedure in this section, the Grizzly Service Department will be happy to guide you through the procedures or help in any other way.
Replacing Belts
To ensure optimum power transmission from the motor to the blades, the belts must be in good condition (free from cracks, fraying and wear) and operate under proper tension.
To change the main blade arbor
1.Disconnect the saw from the power source!
2.Move the blade tilt to 45˚, lower the main blade all the way down, and open the motor cabinet door.
3.Loosen the belt tension bolt (Figure 80) and pivot the motor up.
Figure 80. V-belt tension bolt.
G0588/G0591 12" Sliding Table Saws |
