![](/images/new-backgrounds/1283300/28330091x1.webp)
Crosscutting full size panels: | 4. | Load the workpiece onto the table saw. The | |
| set up should look similar to Figure 58. | ||
1. Install the crosscut fence in the forward |
| ||
|
| ||
| mounting points shown in Figure 60 and lock | 5. | Once all the necessary safety precautions |
| it in place. | ||
|
| have been taken, perform the cutting opera- | |
|
|
| |
|
|
| tion. |
|
| Crosscutting using the rip fence as a | |
|
|
| |
| Rear Mounting | 1. | Install the crosscut fence in the rear mount- |
| Points |
| ing points shown in Figure 60 and lock it in |
| Forward |
| place. |
|
|
| |
| Mounting Points | 2. | Check to make sure the fence is at 90˚ and |
|
| ||
|
|
| adjust it as described in Squaring Crosscut |
|
|
| Fence to Blade on Page 48 if necessary. |
|
| 3. | Position the rip fence for the desired width. |
| Figure 60. Crosscut fence mounting points. | 4. | Load the workpiece onto the table saw. The |
2. |
|
| set up should look similar to Figure 59. |
Check to make sure the fence is at 90˚ and | 5. |
| |
| adjust it as described in Squaring Crosscut | Slide the leading end of the rip fence behind | |
| Fence to Blade on Page 48 if necessary. |
| the back edge of the blade as shown in |
3. |
|
| Figure 61. |
Set either flip stop to the desired |
|
| |
| cut. |
|
|
4. | Load the workpiece onto the table saw. The |
|
|
| set up should look similar to Figure 57. |
|
|
5.Once all the necessary safety precautions have been taken, perform the cutting opera- tion.
Crosscutting smaller panels:
1.Install the crosscut fence in the rear mount- ing points shown in Figure 60 and lock it in place.
2.Check to make sure the fence is at 90˚ and adjust it as described in Squaring Crosscut Fence to Blade on Page 48 if necessary.
3.Set either flip stop to the desired
Figure 61. Correct rip fence position when using it as a cut-off gauge.
6.Take all the necessary safety precautions, then perform the cutting operation.
G0588/G0591 12" Sliding Table Saws |