SECTION 4: OPERATIONS
Operation Safety |
| Operational |
|
| Overview |
| ||
| ||
|
|
|
|
|
|
Damage to your eyes, lungs, and ears could result from using this machine without proper protective gear. Always wear safety glasses, a respirator, and hearing protection when operating this machine.
Loose hair and cloth-
ing could get caught in
machinery and cause seri-
ous personal injury. Keep
loose clothing and long
hair away from moving machinery.
NOTICE
If you have never used this type of machine or equipment before, WE STRONGLY REC- OMMEND that you read books, trade maga- zines, or get formal training before begin- ning any projects. Regardless of the con- tent in this section, Grizzly Industrial will not be held liable for accidents caused by lack of training.
The Model G0641 was designed to make two pre- cise and matching 45° cuts in a
The stock is positioned on the table up against the fence and the adjustable stop. When the foot pedal actuator is pressed, the pneumatic hold- downs lower to hold the workpiece and the blades swing down in a controlled manner to make the cuts.
The resulting workpiece will have opposing 45° cuts on the ends, and the triangular waste piece exits the machine down through the waste chute.
The vertical movement of the clamping hold- downs and saw blades is pneumatically controlled and the rate can be independently adjusted.
To make a cut:
1.Position the
2.Adjust the lowering rates for the
3.Set the fence stop at the correct distance for your operation (Page 21).
4.Turn the saw ON, then press the foot pedal actuator to make the cut.
