3.Loosen the jam nut on the hold-down (clamp) lowering speed knob, then turn the knob to adjust the speed (see Figure 18).

Lowering Speed Knob

Figure 18. Hold-down lowering speed control.

4.Remove any material from the table, keep your hands clear of the cutting area, then press the foot pedal actuator to test the low- ering speeds of the hold-downs and blades.

Note: The goal is to make the hold-downs clamp the workpiece BEFORE the saw blades begin the cut.

5.When you are satisfied with the adjustment, re-tighten the jam nut, then lower and secure the front guard.

G0641 Double Miter Saw

fence stop

Fence Stop

Use the fence stop for repetitive cuts of the same dimensions. Loosen the lock lever, slide the stop along the fence rail to the correct setting, then re- tighten the lever (see Figure 19).

Fence Stop

Lock Lever

Figure 19. Fence stop.

The saw blades can remove fingers and hands very quickly. Always keep your hands at least 4" away from the front guard when the saw blades are spinning. If necessary, use push sticks and other safety devices to handle the workpiece.

-21-

Page 23
Image 23
Grizzly G0641 owner manual Fence Stop