Grizzly G0641 To lubricate the blade arbor housings, To lubricate the main ram pivot point

Manual lubrication is required for: 1) blade arbor housings, 2) tie-rod pivot points, and 3) the upper pivot point of the main pneumatic ram.

To lubricate the blade arbor housings:

1.DISCONNECT SAW FROM POWER!

2.DISCONNECT SAW FROM AIR SUPPLY!

3.Raise the front guard up, remove the inner blade guard and blades to access the pivot arm assemblies (see Figure 36).

Blade Arbor Housing

Grease Fitting

Figure 36. Blade arbor housing grease fitting

(left side shown).

4.Clean off the arbor grease fittings, then use a grease gun to add one or two pumps of multi- purpose grease to the arbor housing grease fittings.

5.Re-install the inner blade guard and blades, then lower and secure the front guard before continuing operation.

NOTICE

Adding more than one or two pumps to the arbor housing may cause damage to the seals and require replacement.

To lubricate the tie-rod pivot points:

1.DISCONNECT SAW FROM POWER!

2.DISCONNECT SAW FROM AIR SUPPLY!

-28-

3.Raise the front guard up, and remove the inner blade guard and blades to access the tie-rods (see Figure 37).

Pivot

Points

Figure 37. Tie-rod pivot points (one side shown).

4.Brush a small amount of multi-purpose grease on and around the tie-rod pivot points.

5.Re-install the inner blade guard and blades, then lower and secure the front guard before continuing operation.

To lubricate the main ram pivot point:

1.DISCONNECT SAW FROM POWER!

2.Remove the rear cabinet access panel.

3.Brush a small amount of multi-purpose grease on and around the main ram pivot point (see Figure 38).

Main Ram

Pivot Point

Figure 38. Main pneumatic ram pivot point (shown through the rear cabinet access).

G0641 Double Miter Saw