19.While an assistant holds the metal rod through the faceplate to prevent the spindle from turn- ing in the headstock, tighten the spanner nut until it is snug and seat the outboard bearing, as shown in Figure 67.
Figure 67. Seating outboard roller bearing.
20.Set up a dial indicator, as shown in Figure 68, and while holding the spanner nut with a leather glove, push and pull it toward the tailstock to determine the amount of end play. The correct amount of end play is 0.001"– 0.002".
Figure 68. Using a dial indicator to measure end
play.
21.Loosen or tighten the spanner nut until end play is 0.001"–0.002", tighten the spanner nut an additional 1⁄8 turn to preload the bearings.
22.Put on a pair of leather gloves and remove the spanner nut.
23.Reinstall the speed sensor with the screws you removed earlier (see Figure 69). Make sure the cord does not touch the pulley sheaves or hang down near them.
Tip: To avoid entangling the speed sensor cord in the pulleys, tie it onto the inboard side of the cross support bar inside the head- stock.
Speed
Sensor
Figure 69. Reinstalling speed sensor.
24.Replace the cover on the outboard end of the spindle and secure it with the spindle lock mechanism you removed in Step 5.
25.Thread the spanner nut fully onto the spindle, then secure it with the two set screws.
26.Thread the mounting hub adapter onto the spindle and tighten the three set screws.
27.Align the key in the adapter with the keyway in the outboard mounting hub.
Model G0694 (Mfg. Since 1/09) |
