Tailstock
The tailstock is equipped with a
To position and lock the tailstock in position:
1.Loosen the lock lever and move the tailstock to the desired position along the bed (Figure 12).
Lock Lever
Figure 12. Tailstock lock lever.
2.Re-engage the lock lever to secure the tailstock to the bed.
Note: The hex nut underneath the tailstock may require occasional tightening to restore proper clamping pressure and lever position. When adjusted properly, the lever should be at the horizontal position when the tailstock is fully clamped to the bed.
Always operate the lathe with the tailstock firmly locked to the bed. Otherwise, the workpiece can be ejected causing serious personal injury.
Inboard Tool Rest
The tool rest holder is equipped with a cam- action clamping system to secure it to the lathe bed. When the tool rest holder lock lever is tight- ened, a locking plate lifts up and secures the tool rest assembly to the bed. The tool rest can also be positioned and locked at a specific angle or height.
Positioning Inboard Tool Rest on Bedway
1.Loosen the tool rest holder lock lever and move the tool rest assembly to the desired position on the lathe bed (Figure 13).
Tool Rest |
|
Tool Rest |
|
Lock Handle |
|
Tool Rest | Tool Rest |
Holder | Holder |
Lock Lever |
|
Figure 13. Tool rest controls.
2.Re-engage the tool rest holder lock lever to secure the tool rest assembly in position.
Note: The hex nut underneath the tool rest holder (Figure 13) may require occasional tightening to restore proper clamping pres- sure and lever position. When adjusted prop- erly, the lever should be at the horizontal position when the tailstock is fully clamped to the bed.
Always operate the lathe with the tool rest holder firmly locked to the bed. Otherwise, the workpiece can be ejected causing seri- ous personal injury.
Model G0694 (Mfg. Since 1/09)
